John Bell

Male

Port Elgin, Ontario

Canada

Profile Information:

Aircraft Model
CH 750 Cruzer
Project Status
Just started
Building From
Partial kit
Engine installed (or plan to install)
UL Power
Building Experience
Have already built an airplane
Flying Experience
Sport Pilot (or Ultralight)

Comment Wall:

Load Previous Comments

  • Fred Williams

    I did order mine for Aircraft spruce.   I ended  up needing some 90 deg ports off the top and was able to order them directly from Andair.  Surprisingly,  I received them in about a week.   I have heard that they have less than good response times.   They proved me wrong.  It is a well built valve.   I had one in the RV 10 that I built before the cruzer.  

    Dr Fred

    Nov 26, 2018

  • Greg Priest

    Hi John I noticed from your side on photo that you must have custom cut your windscreen at the sides where that useless part of the Lexan wraps down the side of the fuse. It really looks nice. I am at that stage of contemplating how to install the Cruzer windscreen but I'm scared to cut those side flaps off which seem to interfere with other rivet holes etc. If I left it as per the supplied Cruzer windscreen it looks awful and the inside will become an insect trap area where a vacuum cleaner would not reach. HOW DID YOU FIND THE RIGHT SIDE CURVE and was there any installation Knock on's that affected the install. 

    Nov 27, 2020

  • Greg Priest

    Thanks John I will cut mine down at the sides like in your picture.

    Regards

    Greg Priest

    750 Cruzer

    Dec 1, 2020