David R Ferrell
  • Daytona Beach, FL
  • United States
Share on Facebook
  • Blog Posts
  • Discussions (158)
  • Events
  • Groups
  • Photos
  • Photo Albums
  • Videos

David R Ferrell's Friends

  • James E
  • Rich Baxter
  • jrsheldon22
  • Bart mcCoy
  • Joe Zinkel
  • Les Bolen
  • Tom Neal
  • Sebastien Heintz

David R Ferrell's Discussions

650B with UL Power 350iS for sale ... SOLD

Started this discussion. Last reply by David R Ferrell Nov 13, 2023. 3 Replies

Zenith 650B for sale by owner/builder. Plane is beautiful in and out and flies great. Always hangered, NDH, full logs, excellent POH including interactive weight and balance. Meticulous build…Continue

SB 2019-02 for the Bypass

Started this discussion. Last reply by David J. Beaulieu Aug 17, 2023. 3 Replies

Have any of you completed this SB to add this bypass between the fuel supply and return lines?  It applies to my 350iS and most older UL engines with serial numbers below 191401. It's not…Continue

Typical Amps Reading in 350iS

Started this discussion. Last reply by John Bell Aug 11, 2022. 7 Replies

I was getting a lot of variance in my voltage and amps. I changed the regulator out with a much more robust unit with a far better wiring harness set up. Also replaced a 5 year old battery. Upon a…Continue

Dynon Update 16.0.3

Started this discussion. Last reply by Michael Shewan Nov 11, 2021. 5 Replies

Just noticed that this release of Dynon's software says it now has support for EMS configuration for 4 cyl UL engines. Anyone tried this and is there any new info that you can now see via the…Continue

 

David R Ferrell's Page

Latest Activity

David R Ferrell posted a discussion

SB 2019-02 for the Bypass

Have any of you completed this SB to add this bypass between the fuel supply and return lines?  It applies to my 350iS and most older UL engines with serial numbers below 191401. It's not mandatory.The purpose as I understand it, is to make an engine restart easier in the event of an engine failure in flight caused by air in the system, unporting one of the tanks fuel feeds, or running a tank dry.I'm trying to get an idea of how difficult this modification is to install and are the benefits…See More
Aug 15, 2023
3 Comments
David R Ferrell posted a discussion

Typical Amps Reading in 350iS

I was getting a lot of variance in my voltage and amps. I changed the regulator out with a much more robust unit with a far better wiring harness set up. Also replaced a 5 year old battery. Upon a ground test I was seeing better voltage in the 12.5 to 13.1 range but still not the expected 14v. And the amps were still jumping around and often showing a negative 4 to 14 which is so odd.When we built the plane 9 years ago we put in a B&C over voltage unit. I have always felt that was a mistake…See More
May 19, 2022
7 Comments
David R Ferrell posted a discussion

Dynon Update 16.0.3

Just noticed that this release of Dynon's software says it now has support for EMS configuration for 4 cyl UL engines. Anyone tried this and is there any new info that you can now see via the EMS? I'm going to install it this week and hoping that I can now be able to see MAP since I installed the MAP sensor during the build and have never used it!See More
Nov 6, 2021
5 Comments
David R Ferrell posted a discussion

Erratic CHT Reading

I wasn't sure where to post this.I have a UL 350iS with a Dynon Skyview system with the Dynon EMS in a CH650B. It's all been working fine for 450 hrs but now I'm getting an erratic CHT reading on #4. It usually resolves itself within 10 min of take off but before that I'm seeing readings that jump all over the place from minus 150 degrees to plus 200 and sometimes it reads zero and the CHT label for #4 is x'd out on the screen as if it wasn't there at all. All other CHT's from the other…See More
Nov 2, 2021
3 Comments
David R Ferrell posted a discussion

350iS Oil Temps

Just finished my annual inspection with 400 hrs on the 350iS. With minor exceptions the engine has been awesome so far. Compression's are all high 70's, oil usage is less than 1/2 qt in 50 hours. Every couple years one of the valves needs a minor tweak. No leaks, starts great. No complaints!Just curious...what kind of oil temps are other 350iS users seeing. I typically run between 186 and 210. The 210 is rare on only after a climb in the dead of summer. I'd say my average is about 190. Those…See More
Nov 21, 2019
7 Comments

Profile Information

Aircraft Model
ZODIAC CH 650
Project Status
Less than half
Building From
Kit
Building Experience
No Experience
Flying Experience
Private Pilot

Comment Wall (3 comments)

You need to be a member of Zenith Aircraft Builders and Flyers to add comments!

Join Zenith Aircraft Builders and Flyers

At 9:55pm on August 8, 2015, Rich Baxter said…

Ah yes - going to be an interesting journey!  Sold my Kitfox 5 last week and looking forward to getting the kit shipped and getting to work.  I may take you up on your offer to see how the cockpit fits related to the rudder pedal location. Beefed up seat cushioning may be a simpler solution.  I actually went to Lake Ridge and took about two dozen pictures of your aircraft just to get an idea of how some things went together.  For instance, the aileron on your a/c is hinged whereas the 610 uses a non-hinged aileron.  I have a lot to learn.

At 11:05am on November 14, 2012, David Josephson said…

Hi David

Hope you don't mind that your thread on Jab vs UL has been hijacked to be a grill-UL session but I think it's all good information as long as Robert will step up to the plate and answer questions. Hopefully Jab will also respond.

At 3:52pm on November 5, 2012, Bart mcCoy said…
Hi David:

I know you will enjoy this project if you like putting things together.

Have fun!
 
 
 

New from Zenith:

Zenith Planes For Sale 
  

Classified listing for buying or selling your Zenith building or flying related stuff...

Custom Instrument Panels
for your Zenith:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.

Zenith Homecoming Tee:

Zenair Floats

Flying On Your Own Wings:
 A Complete Guide to Understanding Light Airplane Design, by Chris Heintz

Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service