Just finishing the 15 hr service after rebuild on my UL350iS.  Required a torque check on the cylinder head bolts.  If torque has loosened (not uncommon) you need to retorque all 16 cylinder head bolts.  Each cylinder has two of the bolts which are not accessible without a bit of extra work.  The bottom cylinder bolts required removal of the valve cover, lock tab and cylinder head plug.  Get at it while checking and setting the tappets.  The top cylinder head bolts require lifting the inlet manifolds about an inch or  two to access.  When going to remove the inlet manifold bolts, I discovered one that was completely loose (despite nordlock washer) and could be removed with my finger. Closer inspection revealed stripped threads!  I already had a proper helicoil kit for the M6 bolt size since I had inserted one helicoil already for a stripped exhaust bolt hole. Anyway, got it done today and should be able to do test runs later this week.  The good news is that the engine so far has been running well, no prop flange issues as of yet with the new crank and prop flange and WW prop.  Also note that the 5 and 15 hr prop flange bolt torque check has been eliminated if new engine or rebuild by factory/authorized repair station.  The picture below shows the freshly tapped hole ready for helicoil insert.

Views: 1181

Reply to This

Replies to This Discussion

Scott, 

Plugs:

NGK plugs are on order and currently lost in transit. Will not know numbers until they arrive. Any parts house should be able to cross reference numbers.

Bosch FR5DTC, my last ones were made in Russia, maybe why I am having a difficult time ordering Bosch.

Fine fuel filter:

Wix 33008

Parts Master 73008


Good luck finding fuel pump.

Ralph

Thanks for the info...

Scott,

It turns out that NGK plugs have two electrodes vs three on the Bosch. I ended up ordering the Bosch online. The senior parts man at the auto parts store believes that Bosch and E3 are the only two companies that make three electrode plugs. The Bosch plugs are made in Russia, that may impact availability.

Ralph

I noticed that as well.  I also have a set of unused plugs in the Hangar and also see where they came from Russia.  Maybe UL power needs to consider finding an alternative?

Interestingly, I just went back to the UL Power oil filter and using a hose clamp for a safety wire attach point.  I had been using the K&N filter because of the hex nut and drilled hole for safety wire. I was not worried about any sort of factory warranty when I switch to the K&N.  With an overhauled or new engine under some sort of warranty I would consider using only the UL specified components...you know - just in case there was an issue of some sort ;)

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service