Replies to This Discussion

Permalink Reply by Glenn Davis on February 6, 2018 at 7:21am

That's nice looking Jim.

As another forum member once told me "you are 50% done, only another 100% to go". Some tips on your engine : you will need to grind off some engine housing on either side of the flywheel to get the cowling to fit. Jan mentions this in one of his videos and I had to replace the exhaust pipe on my Viking supplied muffler because the original was going to penetrate the cowl as it drops down and transitions to the air ram.

• ▶ Reply

Permalink Reply by Jim Davis on February 6, 2018 at 7:27am

Thanks and thanks for the tips! Feel free to throw out as many as you want :-)

 Are you still on schedule to move to the hangar?

• ▶ Reply

Permalink Reply by Glenn Davis on February 6, 2018 at 7:56am

Had to delay the move by a couple of weeks due to a problem with the canopy as in I had to replace it. Hopefully next week.

• ▶ Reply

Permalink Reply by Jim Davis on February 6, 2018 at 8:44am

Bummer about the canopy :-( I was over at the Zenith factory last week and we were talking about the canopy and Steve said he has to ship quite a few new ones all the time.

 Good luck with the new one .

• ▶ Reply