Replies to This Discussion

Permalink Reply by Mark Townsend on February 15, 2009 at 1:24pm

if your talking about the hole in the wing skin to the filler nect then take a trip; over to the local home depot aeronautical store and go to plumbing section. you are looking for the rubber seal for a toilet tank to the toilet base. this will fit your neck perfectly to the skin, it will also eliminate any syphon of any fuel with full tanks. you may need to drill a small hole in the top of your fuel cap if the seal is too high and stops the vented cap from working.

• ▶ Reply

Permalink Reply by Robert P. and Elaine Sumrall on February 15, 2009 at 10:17pm

What I am looking for is something to cover up the fuel sensor that sit on top of the fuel tank.Not the fuel neck where you put the gas in. Please help if you can. Thanks

• ▶ Reply

Permalink Reply by Debra and Patrick Nesbitt on February 15, 2009 at 10:25pm

Hi Robert, I saw a picture of a fuel tank in a 701 wing tank with the fuel sender located on top of the tank. What the person had done was glued a piece of rubber tire tube over it before enclosing wing. Hope this helps

• ▶ Reply

Permalink Reply by Taylor Ogden on February 16, 2009 at 8:59pm

On the 801 my dad and I are putting together, we elected to put in nuit plates and make the skin above the wing tanks removable with screws like my Cessna 150 instead of riviting on....

• ▶ Reply