Online Community of Zenith Builders and Flyers
I need to terminate my throttle cable at the carburetor. I am thinking of using the end fitting shown below. I am a little concerned that this might not be a "positive enough" termination. Any advice/alternate ideas would be appreciated. Carb is an Ellison EFS-3A and has a 1/4" ball end on the direct push-pull slider - not a rotating part like butterfly throttles.
I am also trying to figure out my throttle linkage... but I am using a Stromberg carb on a HDS gravity flow model. Sorry I'm not any help. Maybe someone here has some expertise in hooking up aircraft carbs. I would rather not deviate from the standard method myself.