Comment

Comment by giuseppe lomonaco on December 14, 2009 at 10:07am

hi Mike ,i,m working also up to ch 750,very nice job!
just now i,m working up to front firewall,i don't have any instructions for assembly, i 've find in your picture a good help.
You can post some other picture about gas control and heat carburator?
Thanks a lot
Peppe

Comment by Mike Schlichtman on November 30, 2009 at 10:27pm

Stephen, I want to thank you for your comment. I went back and reread the instructions and did find a flaw in my installation. My sensor does not nessearily need to be level, but the wire needs to be oriented up so as air bubbles can escape. I went ahead and relocated the sensor on the floor so that it is both level and wires up. I called GRT and they said many guys have install like what is pictured here and it seems to work fine...but I decided to relocate anyway. thanks

Comment by Mike Schlichtman on November 25, 2009 at 11:07am

My instructions only indicated that I have at least five inches of semi straight line on both end and that the out port be level or higher than the in. As far as I can tell, this one has a little impeller that spins and that it can be oriented in just about any configuration within the guide lines I mentioned.

Comment by Stephen R. Smith on November 25, 2009 at 8:40am

FYI, some fuel flow sensors require a level orientation - not sure about yours.