Comment

Comment by Jean-Paul Chevalier on March 14, 2016 at 2:03pm

Thomas, I used 3M spray adhesive. The entire panel was then coated with a high gloss clear epoxy. I have used this method before with good success. I can't however comment on FL as we live in dry NM.

Comment by Thomas Richardson on March 12, 2016 at 2:11pm

Jean-Paul, Beautiful panel. Curious as to what you used to put the veneer on ( adhesive) and have you had any issues with the veneer staying in place. I live in Florida where we have high humidity, especially in the summer. My plane will be hangared. Thanks, Tom

Comment by Jean-Paul Chevalier on August 24, 2015 at 7:40am

Vance, here is the basic rundown. Tablet for navigation (Garmin Pilot with synthetic vision), MGL Xtreme for pitot static flight data and full engine monitoring, Sandia Aerospace transponder, hard mounted Icom handheld radio, digital carbon monoxide sensor, a backup steam gauge for airspeed, trim and flap position LEDs and dual throttles.

Comment by Vance Lucas on August 21, 2015 at 11:05pm

Hi Jean-Paul, that is a nice looking panel can you elaborate a little on what you have installed in it? I am approaching the panel stage and haven't decided which way to go.

 

Thanks, Vance