Building Hints, Tips and Tricks

Building Hints, Tips and Tricks. We invite you to share you "building tips, hints, and tricks" in this new discussion forum.
Note: This is non model specific forum: If you have a building tip, hint, and trick that is specific to a model please post to model specific forums.

Views: 9980

▶ Reply to This

Replies to This Discussion

Permalink Reply by Lee Loker on February 9, 2011 at 7:05am

I should know something by this afternoon as far as price the material just came in yesterday...There are four in a complete set 2" 2.5" 3.75" and 4.5" 

 

Permalink Reply by Lee Loker on February 3, 2011 at 10:03am
I know this is common to a lot of people but for scratch building it is a huge time saver! Any part that requires 4 or more pieces i cut a plywood template and router the peices out...Bosch pt# 85285MC Is a very inexpensive cutter that does a great job on material up to .063....any thicker i use Bosch pt# 85268MC
Permalink Reply by John Austin on May 28, 2011 at 10:11pm

A standard 6-flute deburring bit with a 1/4 x 28 thread will snugly fit insite a female hex socket. You can either JB Weld the bit directly into an inexpensive power screwdriver OR (to keep from having to toss the screwrdriver when the bit gets dull!) if you can find a "hex bit extension" (commonly included with inexpensive tool sets like you buy at Sam's club), you can epoxy the bit into the extension and be able to remove it from the driver and use the driver for other things.! I happened to have 2 or 3 of the hex bit extensions, so I figure when the bit gets dull, I can just make up another one with a new extension and a new bit.

 

Works great and no wobble!

 

Regards,

John

Permalink Reply by Terrence "Dr. Terry" Hall on October 13, 2018 at 12:16pm

Anyone have plans for a Zenith Cruzer nose wheel puller so I don't have to buy one from Zenith.

Dr. Terry Hall

Permalink Reply by Gary Welch on October 13, 2018 at 5:21pm

Wood skewers - Typical kitchen wood skewers are slightly smaller than the typical cleco. They are great for a quick fit up, and or to align holes when you dont need to cleco.

I have found a bunch of other uses for these including applying small amounts of sealant or lubricants,  wrapping duct tape on the end with sticky side out to pick up screws or nuts that fall into unreachable places, mixing epoxy, etc..

I seem to frequently find now uses for these in the hangar.

RSS

New from Zenith:

Zenith Planes For Sale 
  

Classified listing for buying or selling your Zenith building or flying related stuff...

Custom Instrument Panels
for your Zenith:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.

Zenith Homecoming Tee:

Zenair Floats

Flying On Your Own Wings:
 A Complete Guide to Understanding Light Airplane Design, by Chris Heintz

Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service