Replies to This Discussion

Permalink Reply by Paul Sanders on December 3, 2020 at 5:23pm

Wait, the floats I bought last year were absolutely the last redesign, never going to leak etc etc!! Makes me wonder how good the rest of my engine is when they can't make something as simple as these things.

I suppose its possible that the "new" floats are actually the ones I already have, otherwise I'll be on my third replacement in just two years, pretty crappy.

• ▶ Reply

Permalink Reply by Chris Hoare on December 3, 2020 at 8:12pm

I know how you feel think it should be at there expense if they can’t get it right starting to get fed up with it .

• ▶ Reply

Permalink Reply by Michel Ruf on December 7, 2020 at 4:31am

My engine is not in the serial no. list. But I had to exchange the floats with SB-912-067. The new floats were marked with 2 dots. Does anyone know if this SB applies to me because I have no clue what part no. the floats with the dots have?

• ▶ Reply

Permalink Reply by Jim and Amelia Isaacs on December 9, 2020 at 6:46pm

Hi Michel,

It appears your two dot floats must be replaced with the new floats marked with an “R”, please read this: https://www.rotax-owner.com/en/rotax-blog/item/71-rotax-carb-floats... 

Jim

• ▶ Reply

Permalink Reply by Michel Ruf on December 10, 2020 at 12:22pm

Hi Jim, right on the spot. Thanks a lot.

Michel

• ▶ Reply

Permalink Reply by Jim and Amelia Isaacs on December 10, 2020 at 12:39pm

Servus! 

• ▶ Reply

Permalink Reply by Chris Hoare on December 11, 2020 at 4:33am

I have been advised to give engine number to Rotax and they should cover replacement parts.

here in Australia will find out next week for sure.

• ▶ Reply

Permalink Reply by Chris Hoare on December 12, 2020 at 4:07pm

Found this hope it helps 

• ▶ Reply