Comment

Comment by Jerry "Sonny" Webster on February 17, 2012 at 4:00pm

I didn't realize this material was from Aircraft Spruce.  Very nice that they have the protective covering.  The materials from Trident are not protected but I've had good luck getting sheets without scratches or other damage.

Comment by Jerry "Sonny" Webster on August 13, 2011 at 5:32pm

Should you need more 4x12 sheet's of 6061-T6 sheets I recommend Trident in Houston.  They are only a couple miles from my office so I've been purchasing a sheet or two at a time as needed for each phase.  They will roll them in protective corrugated for you too.  This helps with the cash flow.

Comment by Ron D Leclerc on August 13, 2011 at 8:52am

Hey Jeff..

Are you scratch building... you will be more then satisfied if you are!  Keep in mind it's not the end result... but the journey.  You will be tempted to go like hell... don't take your time and enjoy the process!

Ron

Comment by Jeff Peters on August 12, 2011 at 3:01pm

received all my metal today. 500lb pallet delivered to the office. slide it off the back of the truck. rolled up 4-5 sheets together in bundles..other than heat stroke it feels like xmas around here