After a couple of weekends of work I have finished making a 1/4" radius nosebar for my brake. Since there are very few pieces that need a 1/4" radius bend I originally tried to make a nose bar out of plywood to use on my 4 foot brake. However it was just not up to the task of bending the .063 pieces of aluminum needed for the firewall.

I fabricated a similar 1/8" radius nosebar four or five years ago. This is not the first time I have made a nosebar. The stands I made, mentioned in…

While ordering 4130 tubing for making various steel parts of my project I noticed that the 1-1/8" with .058 inch wall tubing has an inner diameter of just over an inch. I happen to have some 1" acme rod and nuts that would fit quite nicely  inside that tube. After scavenging pieces from a few other stands I was able to put together the following

Instead of…