Today was the day, not the best of days hot and blustry but clear. Rolled down the runway and lifted off for the 1st time, have to admit I was a bit nervous and pretty shakey but into the air we went turblance and all, managed to get it straightened around and rounded the pattern for the 1st landing, kept the speed up as was suggested by the facory pilot and came in about 80, rolled out and caught my breath and talked over the 1st flight with my A&P, Rolled out for the second flight and… Continue

Joe made a suggestion about Zenith builders flying to and attending the 2011 EAA Air Venture as a mass group, I made a suggestion and Joe asked me to do a blog about it so everyone could read it:

I am an 801 builder from Beloit, WI operating out of Southern Wisconsin Regional Airport in Janesville,WI (KJVL) your suggestion sounds good to me and I might suggest that if we wanted to have a mass type fly in the airport in Janesville has plenty of room for us to organize, low fuel…

Continue

Today I de-magnatized the down tubes of the cabin frame and the area immediatly in front of where the magnetic compass will sit, after checking the area I found I was successful in the de-magnetising process.

For information purposes to other builders I purchased a small hand held de-magnitizer unit from McMaster-Carr for $84.00 and it only took about 6 minutes to do the job. Word of caution I was careful to keep my distance from my Dynon D10A as it has an internal magnatometer that…

Continue